558
Parameters
egp as-number: Sets the ORIGIN attribute to EGP. The as-number argument specifies an AS number in the
range 1 to 4294967295 for EGP routes.
igp: Sets the ORIGIN attribute to IGP.
incomplete: Sets the ORIGIN attribute to UNKNOWN.
Examples
# Configure node 10 in permit mode for routing policy policy1 to set the ORIGIN attribute for routes
matching AS path list 1 to IGP.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match as-path 1
[Sysname-route-policy-policy1-10] apply origin igp
apply preference
Use apply preference to set a preference for a routing protocol.
Use undo apply preference to restore the default.
Syntax
apply preference preference
undo apply preference
Default
No preference is set for a routing protocol.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
preference: Specifies a preference in the range of 1 to 255.
Usage guidelines
If you have set preferences for routing protocols with the preference command, the apply preference
command sets a new preference for the matching routing protocol. Non-matching routing protocols still
use the preferences set by the preference command.
Examples
# Configure node 10 in permit mode for routing policy policy1 to set the preference for OSPF external
routes to 90.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match route-type external-type1or2
[Sysname-route-policy-policy1-10] apply preference 90
To Next Page
Loading...
Need help?
General
