235
isis dis-name
NOTE:
This command does not take effect on a Point-to-Point interface.
Use isis dis-name to configure a name for a DIS to represent the pseudo node on a broadcast network.
Use undo isis dis-name to restore the default.
Syntax
isis dis-name symbolic-name
undo isis dis-name
Default
No name is configured for the DIS.
Views
Interface view
Predefined user roles
network-admin
Parameters
symbolic-name: Specifies a DIS name, a case-insensitive string of 1 to 64 characters.
Usage guidelines
This command takes effect only on routers that have dynamic system ID to host name mapping enabled.
Examples
# Configure the DIS name as LOCALAREA.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis dis-name LOCALAREA
Related commands
• display isis name-table
• is-name
isis dis-priority
Use isis dis-priority to specify a DIS priority at a specified level for an interface.
Use undo isis dis-priority to remove the configuration.
Syntax
isis dis-priority value [ level-1 | level-2 ]
undo isis dis-priority [ level-1 | level-2 ]
Default
The priority of Level-1 and Level-2 is 64.
To Next Page
Loading...
Need help?
General
