434
Views
Interface view
Predefined user roles
network-admin
Parameters
profile-name: Specifies an IPsec profile by its name, a case-sensitive string of 1 to 63 characters.
Usage guidelines
This command must reference an IPsec profile. For more information about IPsec profiles, see Security
Configuration Guide.
Examples
# Apply IPsec profile profile001 to VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng ipsec-profile profile001
ripng metricin
Use ripng metricin to configure an interface to add a metric to inbound RIPng routes.
Use undo ripng metricin to restore the default.
Syntax
ripng metricin value
undo ripng metricin
Default
The additional metric of an inbound route is 0.
Views
Interface view
Predefined user roles
network-admin
Parameters
value: Adds an additional metric to inbound routes, in the range of 0 to 16.
Examples
# Configure VLAN-interface 100 to add a metric of 12 to inbound RIPng routes.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng metricin 12
ripng metricout
Use ripng metricout to configure an interface to add a metric to outbound RIPng routes.
Use undo ripng metricout to restore the default.
To Next Page
Loading...
Need help?
General
