54
Predefined user roles
network-admin
Parameters
value: Specifies a default metric for redistributed routes, in the range of 0 to 16.
Usage guidelines
When you use the import-route command to redistribute routes from another routing protocol without
specifying a metric, the metric specified by the default cost command applies.
Examples
# Configure a default metric of 3 for redistributed routes.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] default cost 3
Related commands
import-route
default-route
Use default-route to configure all interfaces running a RIP process to advertise a default route with a
specified metric to RIP neighbors.
Use undo default-route to restore the default.
Syntax
default-route { only | originate } [ cost cost ]
undo default-route
Default
No default route is sent to RIP neighbors.
Views
RIP view
Predefined user roles
network-admin
Parameters
only: Advertises only a default route.
originate: Advertises both a default route and other routes.
cost: Specifies a cost for the default route, in the range of 1 to 15. The default is 1.
Usage guidelines
A RIP router configured with this feature does not receive any default route from RIP neighbors.
Examples
# Configure all interfaces running RIP process 100 to send only a default route with a metric of 2 to RIP
neighbors.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
