68
[Sysname-rip-1] maximum load-balancing 2
Related commands
max-ecmp-num
network
Use network to enable RIP on an interface attached to a specified network.
Use undo network to disable RIP on an interface attached to a specified network.
Syntax
network network-address [ wildcard-mask ]
undo network network-address
Default
RIP is disabled on an interface.
Views
RIP view
Predefined user roles
network-admin
Parameters
network-address: Specifies a subnet address where an interface resides.
wildcard-mask: Specifies an IP address wildcard mask. A wildcard mask can be thought of as a subnet
mask, with 1s and 0s inverted. For example, a wildcard mask of 255.255.255.0 corresponds to a subnet
mask of 0.0.0.255. Without this argument, the command uses the natural mask.
Usage guidelines
RIP runs only on an interface attached to the specified network, which can be configured with a wildcard
mask. An interface not on the specified network does not receive or send RIP routes, or advertise its direct
routes.
For a single RIP process, the network 0.0.0.0 command can enable RIP on all interfaces. If multiple RIP
processes exist, the command is not applicable.
If a physical interface is attached to multiple networks, you cannot advertise these networks in different
RIP processes.
Examples
# Enable RIP process 100 on the interface attached to the network 129.102.0.0.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] network 129.102.0.0
Related commands
rip enable
To Next Page
Loading...
Need help?
General
