494
Syntax
maximum load-balancing maximum
undo maximum load-balancing
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
maximum: Specifies the maximum number of ECMP routes. When the maximum number is 1, OSPFv3
does not perform load balancing.
Usage guidelines
The default maximum number of OSPFv3 ECMP routes equals the maximum number of ECMP routes
supported by the system.
If you use the max-ecmp-num command to configure the maximum number of ECMP routes supported by
the system as m:
• The default setting for the maximum load-balancing command is m.
• The value range for the maximum argument of the maximum load-balancing command is 1 to m.
Examples
# Configure the maximum number of ECMP routes as 2.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] maximum load-balancing 2
Related commands
max-ecmp-num
non-stop-routing
Use non-stop-routing to enable OSPFv3 NSR.
Use undo non-stop-routing to disable OSPFv3 NSR.
NOTE:
This command is available in Release 2311P04 and later versions.
Syntax
non-stop-routing
undo non-stop-routing
Default
OSPFv3 NSR is disabled.
Views
OSPFv3 view
To Next Page
Loading...
Need help?
General
