152
Syntax
maximum load-balancing maximum
undo maximum load-balancing
Views
OSPF view
Predefined user roles
network-admin
Parameters
maximum: Specifies the maximum number of ECMP routes. No ECMP load balancing is available when
the number is set to 1.
Usage guidelines
The default maximum number of OSPF ECMP routes equals the maximum number of ECMP routes
supported by the system.
If you use the max-ecmp-num command to configure the maximum number of ECMP routes supported by
the system to m, the default setting of this command is m, and the value range for this command is 1 to
m.
Examples
# Specify the maximum number of ECMP routes as 2.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] maximum load-balancing 2
Related commands
max-ecmp-num
network (OSPF area view)
Use network to enable OSPF on the interface attached to the specified network in the area.
Use undo network to disable OSPF for the interface attached to the specified network in the area.
Syntax
network ip-address wildcard-mask
undo network ip-address wildcard-mask
Default
OSPF is not enabled for any interface.
Views
OSPF area view
Predefined user roles
network-admin
View
OSPF area view
To Next Page
Loading...
Need help?
General
