497
Views
System view
Predefined user roles
network-admin
Parameters
process-id: Specifies an OSPFv3 process by its ID in the range of 1 to 65535. The default process ID is
1.
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify this option, the OSPFv3 process runs on the public network.
Usage guidelines
Specify a router ID for the OSPFv3 process. Otherwise, the OSPFv3 process cannot generate LSAs.
Examples
# Enable OSPFv3 process 120 and configure the router ID as 1.1.1.1.
<Sysname> system-view
[Sysname] ospfv3 120
[Sysname-ospfv3-120] router-id 1.1.1.1
ospfv3 area
Use ospfv3 area to enable an OSPFv3 process and specify an area for on an interface.
Use undo ospfv3 area to disable an OSPFv3 process.
Syntax
ospfv3 process-id area area-id [ instance instance-id ]
undo ospfv3 process-id area area-id [ instance instance-id ]
Default
No OSPFv3 process is enabled on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
process-id: Specifies an OSPFv3 process by its ID in the range of 1 to 65535.
area-id: Specifies an area by its ID, an IPv4 address or a decimal integer in the range of 0 to
4294967295 that is translated into an IPv4 address by the system.
instance-id: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
Examples
# Configure VLAN-interface 10 to run instance 1 of OSPFv3 process 1 in Area 1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 1 area 1 instance 1
To Next Page
Loading...
Need help?
General
