495
Predefined user roles
network-admin
Usage guidelines
OSPFv3 NSR and OSPFv3 GR are mutually exclusive. Do not configure the non-stop-routing command
and the graceful-restart enable command at the same time.
Examples
# Enable NSR for OSPFv3 process 100.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] non-stop-routing
nssa
Use nssa to configure the current area as an NSSA area.
Use undo nssa to restore the default.
NOTE:
This command is available in Release 2311P04 and later versions.
Syntax
nssa [ default-route-advertise [ cost cost | nssa-only | route-policy route-policy-name | tag tag | type
type ] * | no-import-route | no-summary | [ translate-always | translate-never ] | suppress-fa |
translator-stability-interval value ] *
undo nssa
Default
No area is configured as an NSSA area.
Views
OSPFv3 area view
Predefined user roles
network-admin
Parameters
default-route-advertise: Used on an NSSA ABR or an ASBR only. If it is configured on an NSSA ABR, the
ABR generates a default route in a Type-7 LSA into the NSSA area regardless of whether a default route
is available in the routing table. If it is configured on an ASBR, the ASBR generates a default route in a
Type-7 LSA only when the default route is available in the routing table.
cost cost: Specifies a cost for the default route, in the range of 0 to 16777214. If you do not specify this
option, the default cost specified by the default-cost command applies.
nssa-only: Limits the default route advertisement to the NSSA area by setting the P-bit of Type-7 LSAs to
0. If you do not specify this keyword, the P-bit of Type-7 LSAs is set to 1. If the router acts as both an ASBR
and an ABR and FULL state neighbors exist in the backbone area, the P-bit of Type-7 LSAs originated by
the router is set to 0.
To Next Page
Loading...
Need help?
General
