512
undo snmp-agent trap enable ospfv3 [ grrestarter-status-change | grhelper-status-change |
if-state-change | if-cfg-error | if-bad-pkt | neighbor-state-change | nssatranslator-status-change |
virtif-bad-pkt | virtif-cfg-error | virtif-state-change | virtgrhelper-status-change |
virtneighbor-state-change ] *
Default
SNMP notifications for OSPFv3 are enabled.
Views
System view
Predefined user roles
network-admin
Parameters
grrestarter-status-change: Specifies notifications about GR restarter state change.
grhelper-status-change: Specifies notifications about GR helper state change.
if-state-change: Specifies notifications about interface state change.
if-cfg-error: Specifies notifications about error configuration of an interface.
if-bad-pkt: Specifies notifications about error messages received on an interface.
neighbor-state-change: Specifies notifications about neighbor state change.
nssatranslator-status-change: Specifies notifications about NSSA translator state change.
virtif-bad-pkt: Specifies notifications about error messages received on a virtual interface.
virtif-cfg-error: Specifies notifications about error configuration of a virtual interface.
virtif-state-change: Specifies notifications about virtual interface state changes.
virtgrhelper-status-change: Specifies notifications about neighbor GR helper state changes of a virtual
interface.
virtneighbor-state-change: Specifies notifications about the neighbor state changes of a virtual interface.
Examples
# Disable SNMP notifications for OSPFv3.
<Sysname> system-view
[Sysname] undo snmp-agent trap enable ospfv3
snmp context-name
Use snmp context-name to configure an SNMP context for OSPFv3.
Use undo snmp context-name to restore the default.
Syntax
snmp context-name context-name
undo snmp context-name
Default
No SNMP context is configured for OSPFv3.
To Next Page
Loading...
Need help?
General
