6. To conduct starter test, continuously, press ENTER.
BATTERY TEST RESULTS
RESULT ON PRINTER REMEDY
Good battery No action is required
Good recharge
Battery is in a good state
Recharge the battery and use
Charge & Retest
Battery is not charged properly
→ Charge and test the battery again (Failure to charge the battery fully may
read incorrect measurement value)
Replace battery
→ Replace battery and recheck the charging system. (Improper connection
between battery and vehicle cables may cause "REPLACE BATTERY",
retest the battery after removing cables and connecting the tester to the
battery terminal directly prior to replacing the battery)
Bad cell-replace → Charge and retest the battery.
Whenever filing a claim for battery, the print out of the battery test results must be attached.
1. After the battery test, press ENTER immediately for the starter test.
2. After pressing ENTER key, start the engine.
To Next Page
Loading...
Need help?
General
