Remove, disassemble, inspect, reassemble, and install the caliper and note these items:
TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Brake System > Brake System > Rear Disc Brake > General
Information, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Brake System > Brake System > Rear Disc Brake
> General Information
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your
health.
Avoid breathing dust particles.
Never use an air hose or brush to clean brake assemblies.
Do not spill brake fluid on the vehicle; it may damage the paint; If brake fluid gets on the paint, wash it off
immediately with water.
Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
Before reassembling, check that all parts are free of dirt and other foreign particles.
Replace parts with new ones as specified in the illustration.
Make sure no dirt or other foreign matter gets into the brake fluid.
Make sure no grease or oil gets on the brake discs or pads.
When reusing pads, always reinstall them in their original positions to prevent loss of braking efficiency.
Do not reuse drained brake fluid.
Always use Genuine DOT 3 or DOT 4 brake fluid. Non Genuine DOT 3 or DOT 4 brake fluid cause corrosion
and shorten the life of the system.
Coat the piston, piston seal groove, and caliper bore with clean brake fluid.
Replace all rubber parts with new ones.
After installing the caliper, check the brake hose and line for leaks, interference, interference, and twisting.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title
To Next Page
Loading...
Need help?
General
