Hyundai Tiburon 2003 User Manual

2. Remove the battery and check voltage if the red light doesn't flicker.
Standard voltage : 3V
3. Replace the battery if voltage is below 3V and replace the remote control switch if it is inoperable after
replacing the battery.
Battery : Lithium CR2032 (3V, 220mA/h)
PROGRAMMING TRANSMITTER CODE
1. To program the transmitter code, first connect the hi-
scan (pro) to the Data Link Connector (DLC) in drive side
crash pad lower panel.
2. Turn the power on hi-scan (pro) with the ignition switch ON.
3. Select the vehicle model on hi-scan (pro).
4. After selecting "CODE SAVING" menu then button "ENTER" key.
5. Proceed as follow steps and then code saving is completed.
(1) Press [ENGER] key, if you are ready.
(2) Press the transmitter [LOCK] button above 1 second.
(3) If you save transmitter one more, press other transmitter [LOCK] button above 1 second.
(4) Turn the hi-scan (pro) off, and check the keyless entry system.
Page
2
of
2
24.04.2008
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title
...

Hyundai Tiburon 2003 Specifications

General

Brand	Hyundai
Model	Tiburon 2003
Category	Automobile
Language	English