8. Install the upper and lower timing belt covers.
9. Install the power steering pump pulley, idler pulley, tensioner pulley and crankshaft pulley.
10. Using the wrench [16mm], rotate the tensioner arm clockwise (about 14°) and install the belt to the pulley.
11. Install the engine cover.
How to adjust the tension of the timing belt
1. Rotate the crankshaft 2 turns clockwise and measure the projected length of the auto tensioner at TDC ( #1
Compression stroke) after 5 minutes.
2. The projected length should be 7 ~ 9mm (0.27 ~ 0.31in.).
3. Verify that the timing marks of each sprocket are in their specified position.
If the timing marks are not in their specified position, repeat from 6 above.
1. Inspect the belt closely. If the following problems are evident, replace the belt with a new one.
(1) Hardened back surface of rubber
Back surface is glossn, non-elastic and so hardthat when the nail of your finger is pressed into it, no mark
is produced.
(2) Cracked back surface of rubber.
http://www.hmaservice.com/viewer/content.asp?IsPrint=true&imgnum=1&print_title
To Next Page
Loading...
Need help?
General
