V1: Feedrates
17.7 Data lists
Basic Functions
1416 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
17.7.1.3 Axis/Spindle-specific machine data
17.7.2 Setting data
17.7.2.1 Channelspecific setting data
17.7.2.2 Axis/spindle-specific setting data
22240 AUXFU_F_SYNC_TYPE Output timing of F functions
22410 F_VALUES_ACTIVE_AFTER_RESET F function active afterRESET
Number Identifier: $MA_ Description
30300 IS_ROT_AX Rotary axis/spindle
32000 MAX_AX_VELO Maximum axis velocity
32060 POS_AX_VELO Initial setting for positioning axis velocity
32300 MAX_AX_ACCEL Axis acceleration
32320 DYN_LIMIT_RESET_MASK Reset behavior of dynamic limits
34990 ENC_ACTIVAL_SMOOTH_TIME Smoothing time constant for actual values
35100 SPIND_VELO_LIMIT Maximum spindle speed
35130 GEAR_STEP_MAX_VELO_LIMIT Maximum speed of gear stage
35140 GEAR_STEP_MIN_VELO_LIMIT Minimum speed of gear stage
35160 SPIND_EXTERN_VELO_LIMIT Spindle-speed limitation via PLC
Number Identifier: $SC_ Description
42000 THREAD_START_ANGLE Start angle for thread
42010 THREAD_RAMP_DISP Acceleration behavior of axis when thread cutting
42100 DRY_RUN_FEED Dry run feedrate
42101 DRY_RUN_FEED_MODE Dry run feed mode
42110 DEFAULT_FEED Default value for path feed
42600 JOG_FEED_PER_REV_SOURCE Revolutional feedrate control in the JOG mode
43300 ASSIGN_FEED_PER_RES_SOURCE Revolutional feedrate for positioning axes/spindles
Number Identifier: $SA_ Description
43210 SPIND_MIN_VELO_G25 Programmed spindle speed limiting G25
43220 SPIND_MAX_VELO_G26 Programmed spindle speed limiting G26
43230 SPIND_MAX_VELO_LIMS Spindle-speed limitation with G96
Number Identifier: $MC_ Description
To Next Page
Loading...
Need help?
General
