Siemens SINUMERIK 828D Function Manual

B1: Continuouspath Mode, Exact Stop, LookAhead
3.10 Data lists
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
213
3.10.1.3 Axis/spindlespecific machine data
3.10.2 Setting data
3.10.2.1 Channelspecific setting data
20606 PREPDYN_SMOOTHING_ON Activation of the curvature smoothing
28060 MM_IPO_BUFFER_SIZE Number of NC blocks in IPO buffer (DRAM)
28070 MM_NUM_BLOCKS_IN_PREP Number of NC blocks for block preparation (DRAM)
28520 MM_MAX_AXISPOLY_PER_BLOCK Maximum number of axis polynomials per block
28530 MM_PATH_VELO_SEGMENTS Number of storage elements for limiting path velocity
in block
28533 MM_LOOKAH_FFORM_UNITS Storage for the extended LookAhead
28540 MM_ARCLENGTH_SEGMENTS Number of storage elements for arc length function
representation per block
28610 MM_PREPDYN_BLOCKS Number of blocks for velocity preparation
Number Identifier: $MA_ Description
32310 MAX_ACCEL_OVL_FACTOR Overload factor for axial velocity jumps
32431 MAX_AX_JERK Maximum axial jerk when traversing along the path
32432 PATH_TRANS_JERK_LIM Maximum axial jerk at the block transition in
continuous-path mode
32433 SOFT_ACCEL_FACTOR Scaling of acceleration limitation for SOFT
32434 G00_ACCEL_FACTOR Scaling of acceleration limitation for G00
32435 G00_JERK_FACTOR Scaling of axial jerk limitation for G00
32440 LOOKAH_FREQUENCY Smoothing limit frequency for LookAhead
33100 COMPRESS_POS_TOL Maximum deviation with compensation
33120 PATH_TRANS_POS_TOL Maximum deviation when rounding with G645
35240 ACCEL_TYPE_DRIVE DRIVE acceleration characteristic for axes on/off
36000 STOP_LIMIT_COARSE Exact stop coarse
36010 STOP_LIMIT_FINE Exact stop fine
36012 STOP_LIMIT_FACTOR Exact stop coarse/fine factor and zero speed
monitoring
36020 POSITIONING_TIME Delay time exact stop fine
Number Identifier: $SC_ Description
42465 SMOOTH_CONTUR_TOL Max. contour deviation during rounding
42466 SMOOTH_ORI_TOL Max. deviation of the tool orientation during rounding
42470 CRIT_SPLINE_ANGLE Core limit angle, compressor
42475 COMPRESS_CONTUR_TOL Maximum contour deviation in the compressor
Number Identifier: $MC_ Description

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English