W1: Tool offset
18.9 Basic tool orientation
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
1541
18.9 Basic tool orientation
Application
Normally, the orientation assigned to the tool itself depends exclusively on the active machining plane. For
example, the tool orientation is parallel to Z with G17, parallel to Y with G18 and parallel to X with G19.
Different tool orientations can only be programmed by activating a 5axis transformation. The following system
variables have been introduced in order to assign a separate orientation to each tool cutting edge:
Identifiers $TC_DPV3 to $TC_DPV5 are analogous to identifiers $TC_DP3 to $TC_DP5 of the tool length
components.
MD18114
The system variables for describing the tool orientation are only available if machine data is not equal to zero:
MD18114 $MN_MM_ENABLE_TOOL_ORIENT (assign orientation to tool cutting)
Define direction vector
If all four system variables contain 0, the orientation is defined only by the active plane (as before).
If system variable $TC_DPV[t, d] is equal to zero, the other three parameters - if available - define a direction
vector. The amount of the vector is insignificant.
Example:
System variable Description of tool orientation Format Preassignment
$TC_DPV[t, d] Tool cutting edge orientation
INT
0
$TC_DPV3[t, d] L1 component of tool orientation
REAL
0
$TC_DPV4[t, d] L2 component of tool orientation
REAL
0
$TC_DPV5[t, d] L3 component of tool orientation
REAL
0
Indexing: Same as tool system variable $TC_DPx[t, d]
t: T number of cutting edge
d: D number of cutting edge
MD18114 $MN_MM_ENABLE_TOOL_ORIENT
Value = 1 Only system variable $TC_DPV[t, d] is available.
Value = 2 All four system variables are available.
$TC_DPV[1, 1] = 0
$TC_DPV3[1, 1] = 1.0
$TC_DPV4[1, 1] = 0.0
$TC_DPV5[1, 1] = 1.0
To Next Page
Loading...
Need help?
General
