K2: Axis Types, Coordinate Systems, Frames
10.6 Workpiecerelated actualvalue system
Basic Functions
802 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
10.6.3 Special reactions
Overstore
Overstoring in RESET state of:
• Frames (zero offsets)
• Active plane
• Activated transformation
• Tool offset
immediately affects the actualvalue display of all axes in the channel.
Entry via operator panel front
If operations on the operator panel are used to change the values for
"Active frame" (zero offsets, "Parameters" operating area)
and
"Active tool length compensation" ("Parameters" operating area)
, one of the following actions is used to activate these changes in the display:
• Press the RESET key.
• Reselect:
- Zero offset by the part program
- Tool offset by the part program
•Reset:
- Zero offset by overstoring
- Tool offset by overstoring
• Part-program start
MD9440
If the HMI machine data
MD9440 ACTIVATE_SEL_USER_DATA
for the operator panel front is set, the entered values become active immediately in RESET state.
When values are entered in the part-program execution stop state, they become effective when program
execution continues.
To Next Page
Loading...
Need help?
General
