To Next Page

To Previous Page

H2: Auxiliary function outputs to PLC

8.18 Data lists

Basic Functions

Function Manual, 09/2011, 6FC5397-0BP40-2BA0

473

8.18 Data lists

8.18.1 Machine data

8.18.1.1 NC-specific machine data

8.18.1.2 Channelspecific machine data

Number Identifier: $MN_ Description

10713 M_NO_FCT_STOPRE M function with preprocessing stop

10714 M_NO_FCT_EOP M function for spindle active after NC RESET

10715 M_NO_FCT_CYCLE M function to be replaced by subroutine

11100 AUXFU_MAXNUM_GROUP_ASSIGN Maximum number of user-defined auxiliary functions

per channel

11110 AUXFU_GROUP_SPEC Group-specific output behavior

11450 SEARCH_RUN_MODE Behavior after a block search

Number Identifier: $MC_ Description

20110 RESET_MODE_MASK Definition of control initial setting after part program

start.

20112 START_MODE_MASK Definition of control initial setting after powerup and

on RESET or at end of part program

20270 CUTTING_EDGE_DEFAULT Basic setting of tool cutting edge without programming

20800 SPF_END_TO_VDI Subroutine end / Stop at PLC

22000 AUXFU_ASSIGN_GROUP Group assignment of user-defined auxiliary functions

22010 AUXFU_ASSIGN_TYPE Type of user-defined auxiliary functions

22020 AUXFU_ASSIGN_EXTENSION Address extension for user-defined auxiliary functions

22030 AUXFU_ASSIGN_VALUE Value of user-defined auxiliary functions

22035 AUXFU_ASSIGN_SPEC Output behavior of user-defined auxiliary functions

22040 AUXFU_PREDEF_GROUP Group assignment of predefined auxiliary functions

22050 AUXFU_PREDEF_TYPE Type of predefined auxiliary functions

22060 AUXFU_PREDEF_EXTENSION Address extension for predefined auxiliary functions

22070 AUXFU_PREDEF_VALUE Value of predefined auxiliary functions

22080 AUXFU_PREDEF_SPEC Output behavior of predefined auxiliary functions

22100 AUXFU_QUICK_BLOCKCHANGE Block change delay with quick auxiliary functions

22110 AUXFU_H_TYPE_INT Type of H auxiliary functions

22200 AUXFU_M_SYNC_TYPE M functions output time

22210 AUXFU_S_SYNC_TYPE S functions output time

22220 AUXFU_T_SYNC_TYPE T functions output time

Siemens SINUMERIK 828D Function Manual

Other manuals for Siemens SINUMERIK 828D