Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

1000 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
33 :WGEN Commands
:WGEN:ARBitrary:DATA
(see page 1138)
Command Syntax
:WGEN:ARBitrary:DATA {<binary> | <value>, <value> ...}
<binary> ::= single-precision floating point values between
-1.0 to +1.0 in IEEE 488.2 binary block format
<value> ::= floating point values between -1.0 to +1.0
in comma-separated format
The :WGEN:ARBitrary:DATA command downloads an arbitrary waveform in
floating- point values format.
See Also • ":WGEN:ARBitrary:DATA:DAC" on page 1003
• ":SAVE:ARBitrary[:STARt]" on page 608
• ":RECall:ARBitrary[:STARt]" on page 599

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Vertical Resolution	8 bits
Operating Temperature	0 °C to 50 °C
Channels	2 or 4
Display	8.5-inch WVGA (800 x 480)
Input Impedance	1 MΩ ± 1%
Trigger Modes	Edge, Pulse Width
FFT	Yes
Weight	5.5 lbs
Power Requirements	100-240 VAC, 50/60 Hz