Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

432 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
20 :MEASure Commands
:MEASure:PEDGes
(see page 1138)
Command Syntax
:MEASure:PEDGes [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<r> ::= 1-2 in NR1 format
The :MEASure:PEDGes command installs a rising edge count measurement
on screen. If the optional source parameter is not specified, the current
source is measured.
Query Syntax
:MEASure:PEDGes? [<source>]
The :MEASure:NEDGes? query measures and returns the on- screen rising
edge count.
Return Format
<value><NL>
<value> ::= the rising edge count in NR3 format
See Also • "Introduction to :MEASure Commands" on page 406
• ":MEASure:SOURce" on page 444
NOTE
This command is not available if the source is FFT (Fast Fourier Transform).

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English