Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 681
:SBUS<n>:FLEXray:TRIGger:EVENt:AUToset
(see page 1138)
Command Syntax
:SBUS<n>:FLEXray:TRIGger:EVENt:AUToset
The :SBUS<n>:FLEXray:TRIGger:EVENt:AUToset command automatically
configures oscilloscope settings (as shown on the display) for the selected
event trigger.
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:FLEXray:TRIGger:EVENt:TYPE" on page 683
• ":SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID" on page 682
• ":SBUS<n>:FLEXray:TRIGger" on page 679
• ":SBUS<n>:FLEXray:BAUDrate" on page 672
• ":TRIGger[:EDGE]:LEVel" on page 903
• ":SBUS<n>:FLEXray:SOURce" on page 678

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English