Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:TRIGger Commands 31
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 949
:TRIGger:TV:UDTV:ENUMber
(see page 1138)
Command Syntax
:TRIGger:TV:UDTV:ENUMber <count>
<count> ::= edge number in NR1 format
The :TRIGger:TV:UDTV:ENUMber command specifies the Generic video
trigger's Nth edge to trigger on after synchronizing with the vertical sync.
This command is available with the DSOX3VID extended Video triggering
license.
Query Syntax
:TRIGger:TV:UDTV:ENUMber?
The :TRIGger:TV:UDTV:ENUMber query returns the edge count setting.
Return Format
<count><NL>
<count> ::= edge number in NR1 format
See Also • ":TRIGger:TV:STANdard" on page 948
• ":TRIGger:TV:UDTV:PGTHan" on page 952
• ":TRIGger:TV:UDTV:HSYNc" on page 950

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English