422 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
20 :MEASure Commands
:MEASure:DUAL:VPP
(see page 1138)
Overview This measurement is available with the N2820A high sensitivity current
probe when both the Primary and Secondary probe cables are used. This
measurement joins the Zoom In waveform data below the probe's clamp
level with Zoom Out waveform data above the probe's clamp level to create
the waveform on which the measurement is made.
Command Syntax
:MEASure:DUAL:VPP [<source1>][,<source2>]
<source1>,<source2> ::= CHANnel<n> with N2820A probe connected
<n> ::= 1 to (# analog channels) in NR1 format
The :MEASure:DUAL:VPP command installs a screen measurement and
starts a vertical peak-to- peak measurement.
If the optional source parameter(s) are specified, the currently specified
source(s) are modified.
Query Syntax
:MEASure:DUAL:VPP? [<source1>][,<source2>]
The :MEASure:DUAL:VPP? query measures the maximum and minimum
vertical value for the selected source, then calculates the vertical
peak- to- peak value and returns that value. The peak- to- peak value (Vpp)
is calculated with the following formula:
Vpp = Vmax - Vmin
Vmax and Vmin are the vertical maximum and minimum values present on
the selected source.
Return Format
<value><NL>
<value> ::= vertical peak to peak value in NR3 format
See Also • ":MEASure:DUAL:CHARge" on page 418
• ":MEASure:DUAL:VAMPlitude" on page 419
• ":MEASure:DUAL:VAVerage" on page 420
• ":MEASure:DUAL:VBASe" on page 421
• ":MEASure:DUAL:VRMS" on page 423
• "Introduction to :MEASure Commands" on page 406
• ":MEASure:SOURce" on page 444
• ":MEASure:VMAX" on page 459
• ":MEASure:VMIN" on page 460
To Next Page
Loading...
Need help?
General
