Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

590 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:SWITch:VREFerence
(see page 1138)
Command Syntax
:POWer:SWITch:VREFerence <percent>
<percent> ::= percent in NR1 format
The :POWer:SWITch:VREFerence command to specify the voltage switching
level for the switching edges. The value is in percentage of the maximum
switch voltage.
You can adjust this value to ignore noise floors.
This value specifies the threshold that is used to determine the switching
edges.
Query Syntax
:POWer:SWITch:VREFerence?
The :POWer:SWITch:VREFerence query returns the voltage switching level
percent value.
Return Format
<percent><NL>
<percent> ::= percent in NR1 format
See Also • ":POWer:SWITch:APPLy" on page 585
• ":POWer:SWITch:CONDuction" on page 586
• ":POWer:SWITch:IREFerence" on page 587
• ":POWer:SWITch:RDS" on page 588
• ":POWer:SWITch:VCE" on page 589

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English