Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:ACQuire Commands 7
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 233
:ACQuire:SEGMented:ANALyze
(see page 1138)
Command Syntax
:ACQuire:SEGMented:ANALyze
This command calculates measurement statistics and/or infinite
persistence over all segments that have been acquired. It corresponds to
the front panel Analyze Segments softkey which appears in both the
Measurement Statistics and Segmented Memory Menus.
In order to use this command, the oscilloscope must be stopped and in
segmented acquisition mode, with either quick measurements or infinite
persistence on.
See Also • ":ACQuire:MODE" on page 231
• ":ACQuire:SEGMented:COUNt" on page 234
• "Introduction to :ACQuire Commands" on page 227
NOTE
This command is available when the segmented memory option (Option SGM) is enabled.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English