Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 539
:POWer:HARMonics:DISPlay
(see page 1138)
Command Syntax
:POWer:HARMonics:DISPlay <display>
<display> ::= {TABLe | BAR | OFF}
The :POWer:HARMonics:DISPlay command specifies how to display the
current harmonics analysis results:
• TABLe
• BAR — Bar chart.
• OFF — Harmonics measurement results are not displayed.
Query Syntax
:POWer:HARMonics:DISPlay?
The :POWer:HARMonics:DISPlay query returns the display setting.
Return Format
<display><NL>
<display> ::= {TABL | BAR | OFF}
See Also • ":POWer:HARMonics:APPLy" on page 537
• ":POWer:HARMonics:DATA" on page 538
• ":POWer:HARMonics:FAILcount" on page 540
• ":POWer:HARMonics:LINE" on page 541
• ":POWer:HARMonics:POWerfactor" on page 542
• ":POWer:HARMonics:RUNCount" on page 543
• ":POWer:HARMonics:STANdard" on page 544
• ":POWer:HARMonics:STATus" on page 545
• ":POWer:HARMonics:THD" on page 546

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Vertical Resolution	8 bits
Operating Temperature	0 °C to 50 °C
Channels	2 or 4
Display	8.5-inch WVGA (800 x 480)
Input Impedance	1 MΩ ± 1%
Trigger Modes	Edge, Pulse Width
FFT	Yes
Weight	5.5 lbs
Power Requirements	100-240 VAC, 50/60 Hz