Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 587
:POWer:SWITch:IREFerence
(see page 1138)
Command Syntax
:POWer:SWITch:IREFerence <percent>
<percent> ::= percent in NR1 format
The :POWer:SWITch:IREFerence command to specify the current switching
level for the start of switching edges. The value is in percentage of the
maximum switch current.
You can adjust this value to ignore noise floors or null offset that is
difficult to eliminate in current probes.
This value specifies the threshold that is used to determine the switching
edges.
Query Syntax
:POWer:SWITch:IREFerence?
The :POWer:SWITch:IREFerence query returns the current switching level
percent value.
Return Format
<percent><NL>
<percent> ::= percent in NR1 format
See Also • ":POWer:SWITch:APPLy" on page 585
• ":POWer:SWITch:CONDuction" on page 586
• ":POWer:SWITch:RDS" on page 588
• ":POWer:SWITch:VCE" on page 589
• ":POWer:SWITch:VREFerence" on page 590

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English