To Next Page

To Previous Page

1072 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

35 Obsolete and Discontinued Commands

:MEASure:TSTArt

(see page 1138)

Command Syntax

:MEASure:TSTArt <value> [suffix]

<value> ::= time at the start marker in seconds

[suffix] ::= {s | ms | us | ns | ps}

The :MEASure:TSTArt command moves the start marker (X1 cursor) to the

specified time with respect to the trigger time.

Query Syntax

:MEASure:TSTArt?

The :MEASure:TSTArt? query returns the time at the start marker (X1

cursor).

Return Format

<value> ::= time at the start marker in NR3 format

See Also • "Introduction to :MARKer Commands" on page 380

• "Introduction to :MEASure Commands" on page 406

• ":MARKer:X1Position" on page 382

• ":MARKer:X2Position" on page 384

• ":MARKer:XDELta" on page 386

• ":MEASure:TDELta" on page 1068

• ":MEASure:TSTOp" on page 1073

NOTE

The short form of this command, TSTA, does not follow the defined Long Form to Short

Form Truncation Rules (see page 1140). The normal short form "TST" would be the same for

both TSTArt and TSTOp, so sending TST for the TSTArt command produces an error.

NOTE

The :MEASure:TSTArt command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:X1Position command (see page 382) instead.

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series