Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:BUS<n> Commands 8
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 247
:BUS<n>:DISPlay
(see page 1138)
Command Syntax
:BUS<n>:DISplay <value>
<value> ::= {{1 | ON} | {0 | OFF}}
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:DISPlay command enables or disables the view of the selected
bus.
Query Syntax
:BUS<n>:DISPlay?
The :BUS<n>:DISPlay? query returns the display value of the selected bus.
Return Format
<value><NL>
<value> ::= {0 | 1}
See Also • "Introduction to :BUS<n> Commands" on page 242
• ":BUS<n>:BIT<m>" on page 243
• ":BUS<n>:BITS" on page 244
• ":BUS<n>:CLEar" on page 246
• ":BUS<n>:LABel" on page 248
• ":BUS<n>:MASK" on page 249
NOTE
This command is only valid for the MSO models.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English