Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

448 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
20 :MEASure Commands
:MEASure:STATistics:INCRement
(see page 1138)
Command Syntax
:MEASure:STATistics:INCRement
This command updates the statistics once (incrementing the count by one)
using the current measurement values. It corresponds to the front panel
Increment Statistics softkey in the Measurement Statistics Menu. This
command lets you, for example, gather statistics over multiple pulses
captured in a single acquisition. To do this, change the horizontal position
and enter the command for each new pulse that is measured.
This command is only allowed when the oscilloscope is stopped and quick
measurements are on.
The command is allowed in segmented acquisition mode even though the
corresponding front panel softkey is not available.
See Also • "Introduction to :MEASure Commands" on page 406
• ":MEASure:STATistics" on page 446
• ":MEASure:STATistics:DISPlay" on page 447
• ":MEASure:STATistics:RESet" on page 450
• ":MEASure:RESults" on page 438

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English