Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:WAVeform Commands 32
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 985
:WAVeform:SOURce:SUBSource
(see page 1138)
Command Syntax
:WAVeform:SOURce:SUBSource <subsource>
<subsource> ::= {{SUB0 | RX | MOSI} | {SUB1 | TX | MISO}}
If the :WAVeform:SOURce is SBUS<n> (serial decode), more than one data
set may be available, and this command lets you choose from the available
data sets.
When using UART serial decode, this option lets you get "TX" data. (TX is
an alias for SUB1.) The default, SUB0, specifies "RX" data. (RX is an alias
for SUB0.)
When using SPI serial decode, this option lets you get "MISO" data. (MISO
is an alias for SUB1.) The default, SUB0, specifies "MOSI" data. (MOSI is
an alias for SUB0.)
If the :WAVeform:SOURce is not SBUS, or the :SBUS<n>:MODE is not UART
or SPI, the only valid subsource is SUB0.
Query Syntax
:WAVeform:SOURce:SUBSource?
The :WAVeform:SOURce:SUBSource? query returns the current waveform
subsource setting.
Return Format
<subsource><NL>
<subsource> ::= {SUB0 | SUB1}
See Also • "Introduction to :WAVeform Commands" on page 961
• ":WAVeform:SOURce" on page 981

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English