To Next Page

To Previous Page

:RECall Commands 25

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 599

:RECall:ARBitrary[:STARt]

(see page 1138)

Command Syntax

:RECall:ARBitrary:[STARt] [<file_spec>][, <column>]

<file_spec> ::= {<internal_loc> | <file_name>}

<column> ::= Column in CSV file to load. Column number starts from 1.

<internal_loc> ::= 0-3; an integer in NR1 format

<file_name> ::= quoted ASCII string

The :RECall:ARBitrary:[STARt] command recalls an arbitrary waveform.

For internal locations, the <column> parameter is ignored.

For external (USB storage device) files, the column parameter is optional.

If no <column> parameter is entered, and it is a 2-column file, the 2nd

column (assumed to be voltage) is automatically be selected. If the

<column> parameter is entered, and that column does not exist in the file,

the operation fails.

When recalling arbitrary waveforms (from an external USB storage device)

that were not saved from the oscilloscope, be aware that the oscilloscope

uses a maximum of 8192 points for an arbitrary waveform. For more

efficient recalls, make sure your arbitrary waveforms are 8192 points or

less.

See Also • "Introduction to :RECall Commands" on page 598

• ":RECall:FILename" on page 600

• ":SAVE:ARBitrary[:STARt]" on page 608

NOTE

If a file extension is provided as part of a specified <file_name>, it must be ".csv".

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series