Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

1080 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
35 Obsolete and Discontinued Commands
:MTESt:AMASk:{SAVE | STORe}
(see page 1138)
Command Syntax
:MTESt:AMASk:{SAVE | STORe} "<filename>"
The :MTESt:AMASk:SAVE command saves the automask generated mask to
a file. If an automask has not been generated, an error occurs.
The <filename> parameter is an MS- DOS compatible name of the file, a
maximum of 254 characters long (including the path name, if used). The
filename assumes the present working directory if a path does not precede
the file name.
See Also • "Introduction to :MTESt Commands" on page 491
NOTE
The :MTESt:AMASk:{SAVE | STORe} command is obsolete and is provided for backward
compatibility to previous oscilloscopes. Use the :SAVE:MASK[:STARt] command (see
page 616) instead.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English