Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:MTESt Commands 22
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 495
:MTESt:AMASk:CREate
(see page 1138)
Command Syntax
:MTESt:AMASk:CREate
The :MTESt:AMASk:CREate command automatically constructs a mask
around the current selected channel, using the tolerance parameters
defined by the :MTESt:AMASk:XDELta, :MTESt:AMASk:YDELta, and
:MTESt:AMASk:UNITs commands. The mask only encompasses the portion
of the waveform visible on the display, so you must ensure that the
waveform is acquired and displayed consistently to obtain repeatable
results.
The :MTESt:SOURce command selects the channel and should be set before
using this command.
See Also • "Introduction to :MTESt Commands" on page 491
• ":MTESt:AMASk:XDELta" on page 498
• ":MTESt:AMASk:YDELta" on page 499
• ":MTESt:AMASk:UNITs" on page 497
• ":MTESt:AMASk:SOURce" on page 496
• ":MTESt:SOURce" on page 521
Example Code • "Example Code" on page 491

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English