To Next Page

To Previous Page

Obsolete and Discontinued Commands 35

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1079

:MEASure:VSTOp

(see page 1138)

Command Syntax

:MEASure:VSTOp <vstop_argument>

<vstop_argument> ::= value for Y2 cursor

The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to

the specified value corresponding to the selected source. The source can

be selected by the MARKer:X2Y2source command.

Query Syntax

:MEASure:VSTOp?

The :MEASure:VSTOp? query returns the current value of the Y2 cursor.

Return Format

<value> ::= value of the Y2 cursor in NR3 format

See Also • "Introduction to :MARKer Commands" on page 380

• "Introduction to :MEASure Commands" on page 406

• ":MARKer:Y1Position" on page 389

• ":MARKer:Y2Position" on page 390

• ":MARKer:YDELta" on page 391

• ":MARKer:X2Y2source" on page 385

• ":MEASure:SOURce" on page 444

• ":MEASure:TDELta" on page 1068

• ":MEASure:TSTArt" on page 1072

NOTE

The short form of this command, VSTO, does not follow the defined Long Form to Short

Form Truncation Rules (see page 1140). The normal short form, VST, would be the same for

both VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.

NOTE

The :MEASure:VSTOp command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:Y2Position command (see page 390) instead.

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series