Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Obsolete and Discontinued Commands 35
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1081
:MTESt:AVERage
(see page 1138)
Command Syntax
:MTESt:AVERage <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}}
The :MTESt:AVERage command enables or disables averaging. When ON,
the oscilloscope acquires multiple data values for each time bucket, and
averages them. When OFF, averaging is disabled. To set the number of
averages, use the :MTESt:AVERage:COUNt command described next.
Query Syntax
:MTESt:AVERage?
The :MTESt:AVERage? query returns the current setting for averaging.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :MTESt Commands" on page 491
• ":MTESt:AVERage:COUNt" on page 1082
NOTE
The :MTESt:AVERage command is obsolete and is provided for backward compatibility to
previous oscilloscopes. Use the :ACQuire:TYPE AVERage command (see page 239) instead.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English