To Next Page

To Previous Page

Obsolete and Discontinued Commands 35

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1073

:MEASure:TSTOp

(see page 1138)

Command Syntax

:MEASure:TSTOp <value> [suffix]

<value> ::= time at the stop marker in seconds

[suffix] ::= {s | ms | us | ns | ps}

The :MEASure:TSTOp command moves the stop marker (X2 cursor) to the

specified time with respect to the trigger time.

Query Syntax

:MEASure:TSTOp?

The :MEASure:TSTOp? query returns the time at the stop marker (X2

cursor).

Return Format

<value> ::= time at the stop marker in NR3 format

See Also • "Introduction to :MARKer Commands" on page 380

• "Introduction to :MEASure Commands" on page 406

• ":MARKer:X1Position" on page 382

• ":MARKer:X2Position" on page 384

• ":MARKer:XDELta" on page 386

• ":MEASure:TDELta" on page 1068

• ":MEASure:TSTArt" on page 1072

NOTE

The short form of this command, TSTO, does not follow the defined Long Form to Short

Form Truncation Rules (see page 1140). The normal short form "TST" would be the same for

both TSTArt and TSTOp, so sending TST for the TSTOp command produces an error.

NOTE

The :MEASure:TSTOp command is an obsolete command provided for compatibility to

previous oscilloscopes. Use the :MARKer:X2Position command (see page 384) instead.

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series