Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:MEASure Power Commands 21
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 479
:MEASure:IPOWer
(see page 1138)
Command Syntax
:MEASure:IPOWer
The :MEASure:IPOWer command installs an input power measurement on
screen.
Before sending this command or query, you must specify the channels
probing the input voltage, input current, output voltage, and output
current (using the :POWer:SIGNals:SOURce:VOLTage<i> and
:POWer:SIGNals:SOURce:CURRent<i> commands) and you must perform the
automated signals setup (using the :POWer:SIGNals:AUTosetup EFFiciency
command).
Query Syntax
:MEASure:IPOWer?
The :MEASure:IPOWer query returns the measured input power.
Return Format
<return_value><NL>
<return_value> ::= the input power value in NR3 format
See Also • ":POWer:SIGNals:SOURce:VOLTage<i>" on page 582
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 581
• ":POWer:SIGNals:AUTosetup" on page 564
• ":POWer:EFFiciency:APPLy" on page 535

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English