Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

580 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:SIGNals:VSTeady:TRANsient
(see page 1138)
Command Syntax
:POWer:SIGNals:VSTeady:TRANsient <value>[suffix]
<value> ::= Expected steady state output Voltage value in NR3 format
[suffix] ::= {V | mV}
The :POWer:SIGNals:VSTeady:TRANsient command specifies the expected
steady state output DC voltage of the power supply for transient response
analysis.
This value is used along with the overshoot percentage to specify the
settling band for the transient response and to adjust the vertical scale of
the oscilloscope.
Query Syntax
:POWer:SIGNals:VSTeady:TRANsient?
The :POWer:SIGNals:VSTeady:TRANsient query returns the expected steady
state voltage setting.
Return Format
<value><NL>
<value> ::= Expected steady state output Voltage value in NR3 format
See Also • ":POWer:TRANsient:APPLy" on page 591
• ":POWer:SIGNals:AUTosetup" on page 564
• ":POWer:SIGNals:DURation:TRANsient" on page 572
• ":POWer:SIGNals:IEXPected" on page 573
• ":POWer:SIGNals:OVERshoot" on page 574
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 581
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 582

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English