Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 561
:POWer:QUALity:APPLy
(see page 1138)
Command Syntax
:POWer:QUALity:APPLy
The :POWer:QUALity:APPLy command applies the selected power quality
analysis type (:POWer:QUALity:TYPE).
The power quality analysis shows the quality of the AC input line.
Some AC current may flow back into and back out of the load without
delivering energy. This current, called reactive or harmonic current, gives
rise to an "apparent" power which is larger than the actual power
consumed. Power quality is gauged by these measurements: power factor,
apparent power, true power, reactive power, crest factor, and phase angle
of the current and voltage of the AC line.
See Also • ":POWer:QUALity:TYPE" on page 562
• ":MEASure:FACTor" on page 478
• ":MEASure:REAL" on page 486
• ":MEASure:APParent" on page 473
• ":MEASure:REACtive" on page 485
• ":MEASure:CRESt" on page 475
• ":MEASure:ANGLe" on page 472

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English