Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

38 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
1 What's New
:FUNCtion:LINear:GAIN (see page 344) Specifies the 'A' value in the Ax + B operation.
Available with the DSOX3ADVMATH advanced
math license.
:FUNCtion:LINear:OFFSet (see page 345) Specifies the 'B' value in the Ax + B operation.
Available with the DSOX3ADVMATH advanced
math license.
:FUNCtion:TRENd:MEASurement (see
page 355)
Selects the measurement whose trend is
shown in the math waveform. Available with
the DSOX3ADVMATH advanced math license.
:MEASure Power Commands (see page 469) :MEASure commands available when the
DSOX3PWR power measurements and
analysis application is licensed and enabled.
:MEASure:STATistics:DISPlay (see page 447) Specifies whether the display of measurement
statistics is on or off.
:POWer Commands (see page 529) Commands for the DSOX3PWR power
measurements and analysis application.
:PWRenable (Power Event Enable Register)
(see page 216)
For enabling bits in the Power Event Enable
Register. This status register control is
available when the DSOX3PWR power
measurements and analysis application is
licensed.
:PWRRegister[:EVENt] (Power Event Event
Register) (see page 216)
For reading power application status bits in the
Power Event Event Register. This query is
available when the DSOX3PWR power
measurements and analysis application is
licensed.
:RECall:ARBitrary[:STARt] (see page 599) Recalls waveform generator arbitrary
waveforms from a file.
:SAVE:ARBitrary[:STARt] (see page 608) Saves waveform generator arbitrary waveforms
to a file.
:SAVE:POWer[:STARt] (see page 618) Saves the power measurement application's
current harmonics analysis results to a file.
:SBUS<n>:A429 Commands (see page 634) Commands for ARINC 429 triggering and serial
decode.
:SBUS<n>:FLEXray Commands (see page 669) Commands for FlexRay triggering and serial
decode.
:SBUS<n>:M1553 Commands (see page 731) Commands for MIL-STD 1553 triggering and
serial decode.
:SEARch:SERial:A429 Commands (see
page 802)
Commands for finding ARINC 429 events in the
captured data.
Command Description

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English