Cisco Nexus 7000 Series Reference Guide

D Commands
diagnostic clear result module
121
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
diagnostic clear result module
To clear the diagnostic test result for the specified test, use the diagnostic clear result module
command.
diagnostic clear result module [slot | all] test {test-id | all}
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to clear a diagnostic test result:
switch# diagnostic clear result module 6 test 6
Related Commands
slot (Optional) Specifies to clear the a diagnostic test for a specific module number.
The range is from 1 to 10.
all (Optional) Displays the test result for all tests on all modules.
test Displays the diagnostic test selection.
test-id Test ID. The range is from 1 to 14.
Release Modification
4.0(1) This command was introduced.
Command Description
show diagnostic result Displays a diagnostic test result for a specified test.

Cisco Nexus 7000 Series Specifications

General

Chassis	Modular
Operating System	Cisco NX-OS
Latency	Sub-microsecond
IPv6 Support	Yes
Redundancy	Power supplies, fans, supervisors, fabric modules
Power Supply	AC or DC
Layer Support	L2, L3
Network Management	CLI, SNMP
Virtualization	VRF, vPC
Ports	10 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet, Fibre Channel, Fibre Channel over Ethernet (FCoE)
Supported Modules	Various (1G, 10G, 40G, 100G)
Features	FCoE, OTV, LISP
MPLS Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, Cisco TrustSec, Control Plane Policing (CoPP)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5 to 95% noncondensing
MTBF	Varies by model
Number of Slots	Varies by model (9-slot, 10-slot, 18-slot)