Cisco Nexus 7000 Series Reference Guide

C Commands
checkpoint
48
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
checkpoint
To configure the rollback checkpoint, use the checkpoint command. To delete the checkpoint, use the
no form of this command.
checkpoint {name | description description | file name}
no checkpoint name
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines If you use the checkpoint command without a name, Cisco NX-OS creates the file with the name auto-x,
where x is a decimal number that increases each time you create an unnamed checkpoint file.
This command does not require a license.
Examples This example shows how to configure the rollback checkpoint:
switch# checkpoint stable
switch#
This example shows how to delete the checkpoint file:
switch# no checkpoint stable
name (Optional) Checkpoint name used in the checkpoint database. The name
can be any alphanumeric string up to 80 characters but cannot contain
spaces.
description description (Optional) Specifies the checkpoint description for the given checkpoint.
The description can contain up to 80 alphanumeric characters, including
spaces.
file name (Optional) Specifies the filename used to save the checkpoint.
Release Modification
4.0(1) This command was introduced.

Cisco Nexus 7000 Series Specifications

General

Brand	Cisco
Model	Nexus 7000 Series
Category	Switch
Language	English