Cisco Nexus 7000 Series Reference Guide

Show Commands
show hardware capacity
491
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show hardware capacity
To display information about the hardware capabilities and current hardware utilization by the system,
use the show hardware capacity command.
show hardware capacity [eobc | fabric-utilization | forwarding | interface | module | power]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines You can make network design plans based on the information about hardware capabilities and the current
hardware utilization.
This command does not require a license.
eobc (Optional) Displays the Ethernet Out of Band Channel (EOBC) resources, such
as packets per second, total packets, and dropped packets, for both ingress (rx)
and egress (tx) direction.
fabric-utilization (Optional) Displays switch fabric resources, such as the channel speed, the
percentage of egress data, the percentage of ingress data, packet drops, peak
rates, and time stamps.
forwarding (Optional) Displays Layer 2 and Layer 3 forwarding resources, such as available
resources, the percentage of used resources, and the percentage of free resources.
interface (Optional) Displays the chassis, slot, or port number, and the ingress (rx) and
egress (tx) packet drop counter against it.
module (Optional) Displays information about the modules, crossbar resources, and the
percentage of total, free, and used Flash and NVRAM resources in each module.
power (Optional) Displays a summary of the power resources of the system.
Release Modification
4.2.(1) This command was introduced.

Cisco Nexus 7000 Series Specifications

General

Brand	Cisco
Model	Nexus 7000 Series
Category	Switch
Language	English