Cisco Nexus 7000 Series Reference Guide

L Commands
locator-led
240
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
locator-led
To blink an LED on the system, use the locator-led command. To restore the default LED state, use the
no form of this command.
locator-led {chassis | fan f-number | module slot | powersupply ps-number | xbar x-number}
no locator-led {chassis | fan f-number | module slot | powersupply ps-number | xbar x-number}
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines Use the locator-led command to flash the LED on a component in the system. You can use this blinking
LED to identify the component to an administrator in the data center.
This command does not require a license.
Examples This example shows how to blink the LED for module 4:
switch# locator-led module 4
chassis Blinks the chassis LED.
fan f-number Blinks the LED that represents the configured fan number. The range depends on
the platform. Use ? to see the range.
module slot Blinks the module LED. The range depends on the platform. Use ? to see the
range.
powersupply
ps-number
Blinks the power supply LED. The range depends on the platform. Use ? to see
the range.
xbar x-number Blinks the xbar module LED. The range depends on the platform. Use ? to see the
range.
Release Modification
4.1(2) This command was introduced.

Cisco Nexus 7000 Series Specifications

General

Brand	Cisco
Model	Nexus 7000 Series
Category	Switch
Language	English