Cisco Nexus 7000 Series Reference Guide

D Commands
diagnostic monitor interval module
122
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
diagnostic monitor interval module
To configure a diagnostic monitoring test interval on a module, use the diagnostic monitor interval
module command. To remove the diagnostic monitoring test interval, use the no form of this command.
diagnostic monitor interval module module test {all | name | test-id} hour hour min min second
sec
no diagnostic monitor interval module module test {all | name | test-id}
Syntax Description
Defaults None
Command Modes Global configuration mode (config)
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure a diagnostic monitoring test interval on a module:
switch(config)# diagnostic monitor interval module 1 test 5 hour 10 min 30 sec 0
switch(config)#
This example shows how to remove a diagnostic monitoring test interval from a module:
module Module number.
test Specifies a diagnostic test.
all Specifies all test IDs.
name Test name.
test-id Test ID number.
hour Specifies the hour of the interval that the test begins.
hour Hour of the interval that you specify to start the test.
min Specifies the minute of the interval that the test begins.
min Minute of the interval that you specify to start the test.
second Specifies the second of the interval that the test begins.
sec Second of the interval that you specify to start the test.
Release Modification
4.0(1) This command was introduced.

Cisco Nexus 7000 Series Specifications

General

Brand	Cisco
Model	Nexus 7000 Series
Category	Switch
Language	English