Cisco Nexus 7000 Series Reference Guide

L Commands
logging level
247
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
logging level
To enable logging messages from the defined facility that have the specified severity level or higher, use
the logging level command. To disable logging messages from the defined facility, use the no form of
this command.
logging level facility severity-level
no logging level facility severity-level
Syntax Description
Defaults None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
facility Appropriate facility. The facilities are listed in the “System Message Logging
Facilities” section on page 715.
To apply the same severity level to all facilities, use the all facility.
severity-level Number of the desired severity level at which messages should be logged.
Messages at or numerically lower than the specified level are logged. Severity
levels are as follows:
• 0—emergency: System unusable
• 1—alert: Immediate action needed
• 2—critical: Critical condition—default level
• 3—error: Error condition
• 4—warning: Warning condition
• 5—notification: Normal but significant condition
• 6—informational: Informational message only
• 7—debugging: Appears during debugging only
Release Modification
4.0(1) This command was introduced.

Cisco Nexus 7000 Series Specifications

General

Brand	Cisco
Model	Nexus 7000 Series
Category	Switch
Language	English