Cisco Nexus 7000 Series Reference Guide

R Commands
rmon alarm
354
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
rmon alarm
To configure a 32-bit remote monitoring RMON alarm, use the rmon alarm command. To delete RMON
alarms, use the no form of this command.
rmon alarm alarm number mib-object sample-interval {absolute | delta} rising-threshold value
[rising-event] falling-threshold value [falling-event] [owner alarm-owner]
no rmon alarm alarm-number
Syntax Description
Defaults None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
alarm number RMON alarm number. The range is from 1 to 65535.
mib-object MIB object to monitor. The maximum length is 80 characters.
sample-interval Sample interval in seconds. The range is from 1 to 2147483647.
absolute Specifies to test each sample directly.
delta Specifies to test the difference (delta) between the current and previous sample.
rising-threshold
value
Specifies the rising threshold value. The range is from 2147483648 to 2147483647.
rising-event (Optional) Event to trigger on a rising threshold crossing. The range is from 1 to
65535. If no event is specified, event 0 is used.
falling-threshold
value
Specifies the falling threshold value. The range is from 2147483648 to
2147483647.
falling-event (Optional) Event to trigger on a falling threshold crossing. The range is from 1 to
65535. If no event is specified, event 0 is used.
owner alarm
owner
(Optional) Specifies an owner for the alarm. The maximum size is 80 characters.
Release Modification
4.0(1) This command was introduced.

Cisco Nexus 7000 Series Specifications

General

Brand	Cisco
Model	Nexus 7000 Series
Category	Switch
Language	English