Cisco Nexus 7000 Series Reference Guide

Show Commands
show lldp timers
525
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show lldp timers
To display the Link Layer Discovery Protocol (LLDP) hold time, delay time, and update frequency
configuration, use the show lldp timers command.
show lldp timers
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the LLDP hold time, delay time, and update frequency configuration:
switch(config)# show lldp timers
LLDP Timers:
Holdtime in seconds: 180
Reinit-time in seconds: 6
Transmit interval in seconds: 45
switch(config)#
Related Commands
Release Modification
5.0(1) This command was introduced.
Command Description
show lldp holdtime Specifies the amount of time in seconds that a receiving device should hold
the information sent by your device before discarding it.
lldp reinit Specifies the delay time in seconds for LLDP to initialize on any interface.
lldp timer Specifies the transmission frequency of LLDP updates in seconds.

Cisco Nexus 7000 Series Specifications

General

Brand	Cisco
Model	Nexus 7000 Series
Category	Switch
Language	English